(Shown Mistral 26A)

MISTRAL 26/26A

• End milling angle 45° Rh - 90° - 45° Lh and intermediate angles

• Milling tool unit rotation speed 7000 rpm.

• Set up to take integral safety guard around bar being machined to provide maximum noise abatement

• Automatic feed with rapid approach controlled by milling tool unit photocell (Mistral 26 A) or manual (Mistral 26)

• Patented system that allows profile positioning without the need for goniometers

• Tool lubrication by atomizer

• Max. milling tool size Ø175 mm

• Set up for the installation of chips and fumes extraction system

• Integral worktable safety guard with opening lock

• Non-abrasive work table that will not damage painted profiles

• Quick change milling tool unit

• Milling tool unit balancing system

• Milling units magazine with 9 slots

• Maximum milling unit height: 125mm

• Three phase motor: 1.47 Kw (2Hp) – 2800 rpm. – eurovoltage 230/400V– 50Hz; 275/480V – 60 Hz)

• Working pressure: 7 bar

• Work cycle air consumption:

          Mistral 26A = 12 Nl / Work cycle

          Mistral 26 = 0.8 Nl / Work cycle

  Total dimensions 800 x 1040 x 1315 h mm; Kg 187 (Mistral 26 A), Kg 177 (Mistral 26)

OPTIONALS:

• Additional cutters sleeve (including closing spacers)

• Milling cutters

• Surcharge for Micro-drop pure oil blade lubrication system

• Kit for the removal of milled profile burr (only with Mistral 26A)

• Carton packing

• Crate packing

• Soundproofing tunnel with automatic opening with double position (normal opening, opening for elimination of the tunnel for extra-large angle cutting operations: the tunnel "disappears" underneath the working table)

• Special motor

• Plant version UL-CSA with motor with special voltage and drilling unit in inch.